Alien Aircraft Corp AK-504 BB 조립 지침 - 페이지 5

{카테고리_이름} Alien Aircraft Corp AK-504 BB에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Alien Aircraft Corp AK-504 BB 5 페이지. Internal bombay

9...Cut the 1/32" x 12" music wire in half to make two 6" pieces.

Make a 1/4" long 90 degree bend in one end of each wire. Cut

the two 1/16" aluminum tubes to a length of 3-3/8".

10...Slide the tubes onto the music wire. Position the tube 1/2"

from the 90 degree bend and secure the tube to the wire with

thin C/A glue.

12...With the doors open, feed the bent ends of the wire through

the openings in B-05. Gently spring the ends and insert the

wires into the holes in the arms on the doors.

13...With glue or thin servo tape, mount the servo to the top of

the bombay in the position shown. Install an EZ connector on

the servo arm. Bent the top end of the pushrods as shown and

insert them into the EZ connector.

Adjust the pushrods so that the doors just close when the servo

is in the full up position. Tighten the screw on the EZ connector

to hold the wires in place. Trim the wires off close to the con-

nector and lock them in place with a small drop of thin C/A

glue.

Mount the bombay in the bottom of the fuselage with the

pushrods at the rear. Connect the servo to the receiver.

Page 5