a&p instruments UX 3081WQ Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Instrumentos de medida a&p instruments UX 3081WQ. a&p instruments UX 3081WQ 20 páginas. Moisture analysers
Imprimir páginaOperating instructions for moisture analysers
UX 3081
UX 3081WQ
Warranty
a&p instruments undertakes to repair faulty devices within the warranty period, free-of-charge, if the defect is
a manufacturing fault. This warranty covers the repair of spare parts and working hours required. It does not
cover normal wear-and-tear and soiling and staining of the device. a&p instruments will not accept any
freight costs.
This warranty does not apply to:
improper use of the device,
use of the device for purposes other than those stated by a&p instruments,
mechanical damage or damage caused by fluids or sample matter,
incorrect set up or wrong electrical wiring,
mechanical damage of the load cell e.g. as a result of being overloaded
Transport, packaging, installation site
Please check the packaging and device for any damage upon delivery.
Please retain the original packaging in case you need to return the goods to a&p instruments.
Please only use the original packaging when returning the goods.
Accessories supplied:
3081
Tray holder
Start-up
1. 1. Place the device on a stable, vibration-free surface, as level as possible and
protected from draughts. The most suitable locations are the corners of a room,
rooms with only one entrance and heavy tables on concrete floors.
Remove the protective film from the front foil.
1. 2. Swing the heater back until the resistance.
1. 3. Place the tray holder on the device:
First place the tray holder carefully on the two pins, the distance
!
between the housing and the tray holder should be approx. 1.5
– 2 mm. Do not exert to much power on the balance!
a&p instruments, Kluckhofer Weg 61, D-32657 Lemgo, Tel.:05232 97780, Fax.: 977820
E-Mail: [email protected], Internet: www.apinstruments.de
3081
2 trays
Then put on the shielding plate unit.
To remove the tray holder, first carefully lift up the
shielding plates and then carefully pull out the tray
holder in the middle with very slight tilting
movements, do not exert too much power!
für 3081 2x
Tray tongs
Mains cable
Seite 4