a&p instruments UX 3081WQ 사용 설명서 - 페이지 4

{카테고리_이름} a&p instruments UX 3081WQ에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. a&p instruments UX 3081WQ 20 페이지. Moisture analysers

페이지 인쇄

Operating instructions for moisture analysers

UX 3081

UX 3081WQ

Warranty

a&p instruments undertakes to repair faulty devices within the warranty period, free-of-charge, if the defect is

a manufacturing fault. This warranty covers the repair of spare parts and working hours required. It does not

cover normal wear-and-tear and soiling and staining of the device. a&p instruments will not accept any

freight costs.

This warranty does not apply to:

improper use of the device,

use of the device for purposes other than those stated by a&p instruments,

mechanical damage or damage caused by fluids or sample matter,

incorrect set up or wrong electrical wiring,

mechanical damage of the load cell e.g. as a result of being overloaded

Transport, packaging, installation site



Please check the packaging and device for any damage upon delivery.



Please retain the original packaging in case you need to return the goods to a&p instruments.



Please only use the original packaging when returning the goods.

Accessories supplied:

3081

Tray holder

Start-up

1. 1. Place the device on a stable, vibration-free surface, as level as possible and

protected from draughts. The most suitable locations are the corners of a room,

rooms with only one entrance and heavy tables on concrete floors.

Remove the protective film from the front foil.

1. 2. Swing the heater back until the resistance.

1. 3. Place the tray holder on the device:

First place the tray holder carefully on the two pins, the distance

between the housing and the tray holder should be approx. 1.5

– 2 mm. Do not exert to much power on the balance!

a&p instruments, Kluckhofer Weg 61, D-32657 Lemgo, Tel.:05232 97780, Fax.: 977820

E-Mail: [email protected], Internet: www.apinstruments.de

3081

2 trays

Then put on the shielding plate unit.

To remove the tray holder, first carefully lift up the

shielding plates and then carefully pull out the tray

holder in the middle with very slight tilting

movements, do not exert too much power!

für 3081 2x

Tray tongs

Mains cable

Seite 4