LG - Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Monitor LG -. LG - 14 páginas. Led
También para LG -: Manual del usuario (40 páginas), Manual del usuario (22 páginas), Manual del usuario (24 páginas), Manual del usuario (21 páginas), Manual del usuario (39 páginas), Manual del usuario (29 páginas), Manual del usuario (12 páginas), Manual del usuario (12 páginas), Manual del usuario (24 páginas), Manual del usuario (18 páginas), Manual del usuario (16 páginas), Manual del usuario (12 páginas), Manual del usuario (19 páginas), Manual del usuario (15 páginas), Manual del usuario (18 páginas), Manual del usuario (19 páginas), Manual del usuario (13 páginas), Manual del usuario (16 páginas), Manual del usuario (21 páginas), Manual de servicio (29 páginas), Manual del usuario (32 páginas), Manual de instalación (37 páginas)

Connecting the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer

system, and other attached devices, then follow these steps:

Place the monitor in a convenient, well-ventilated location near your computer.

Connect the signal cable.

When connecting the DVI signal cable

Connect the end of monitor signal cable to the port on the rear panel of the monitor through

the slot.

Connect the other end to the DVI port on the rear panel of the computer and

tighten the screws.

When connecting the Dsub signal cable

.......... Figure 2

Connect one end of the monitor signal cable to either of the connectors

panel of the monitor. Connect the other end to the Dsub port on the rear panel of the

computer and tighten the screws.

.......... Figure 3

MAC

Connect one end of the monitor signal cable to either of the connectors

panel of the monitor. Connect the other end of the monitor signal cable to the rear panel of

Macintosh computer through a Macintosh adapter and then tighten screws.

One end of the power cord is connected into the power connetor on the back of

the monitor.

Figure 1

There should be

a DVI port on

the computer

DVI

Note : If you see the INPUT SIGNAL OUT OF RANGE message, check to make sure

your system is set to one of the factory preset modes (see page A11), or is set to a

resolution and refresh rate within the specification limits of this monitor.

Signal Cable

Figure 1

.....

Power Cord

on the rear