LG - Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} LG -. LG - 14 pages. Led
Également pour LG - : Manuel du propriétaire (40 pages), Manuel du propriétaire (22 pages), Manuel du propriétaire (24 pages), Manuel du propriétaire (21 pages), Manuel de l'utilisateur (39 pages), Manuel du propriétaire (29 pages), Manuel du propriétaire (12 pages), Manuel du propriétaire (12 pages), Manuel du propriétaire (24 pages), Manuel du propriétaire (18 pages), Manuel du propriétaire (16 pages), Manuel de l'utilisateur (12 pages), Manuel de l'utilisateur (19 pages), Manuel de l'utilisateur (15 pages), Manuel de l'utilisateur (18 pages), Manuel de l'utilisateur (19 pages), Manuel de l'utilisateur (13 pages), Manuel de l'utilisateur (16 pages), Manuel du propriétaire (21 pages), Manuel d'entretien (29 pages), Manuel du propriétaire (32 pages), Manuel de configuration (37 pages)

Imprimer la page
LG - Manuel de l'utilisateur
Connecting the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer
system, and other attached devices, then follow these steps:
1
Place the monitor in a convenient, well-ventilated location near your computer.
2
Connect the signal cable.
When connecting the DVI signal cable
Connect the end of monitor signal cable to the port on the rear panel of the monitor through
1
the slot.
Connect the other end to the DVI port on the rear panel of the computer and
tighten the screws.
When connecting the Dsub signal cable
.......... Figure 2
PC
Connect one end of the monitor signal cable to either of the connectors
panel of the monitor. Connect the other end to the Dsub port on the rear panel of the
computer and tighten the screws.
.......... Figure 3
MAC
Connect one end of the monitor signal cable to either of the connectors
panel of the monitor. Connect the other end of the monitor signal cable to the rear panel of
Macintosh computer through a Macintosh adapter and then tighten screws.
3
One end of the power cord is connected into the power connetor on the back of
3
the monitor.
Figure 1
There should be
a DVI port on
the computer
DVI
Note : If you see the INPUT SIGNAL OUT OF RANGE message, check to make sure
your system is set to one of the factory preset modes (see page A11), or is set to a
resolution and refresh rate within the specification limits of this monitor.
2
2
2
1
Signal Cable
A2
Figure 1
.....
Power Cord
4
1
on the rear
1
on the rear
2
3