■ Cleaning the Keyboard
To prevent the keyboard from becoming dirty, it should
also be regularly cleaned with a soft, dry cloth.
Always use a dry (not damp) cloth to
ATTENTION
clean the keyboard. Do not apply
Cleaner F1.
For more details, refer to the
"Operator's Guide".
■ Cleaning the Carrier Sheet
If the surface or interior of the carrier sheet becomes
dirty or dusty, use a soft dry cloth slightly moistened
with Cleaner F1 (sold separately) or a mild detergent, to
lightly wipe off the dirt and dust.
z Never use paint thinner or other
ATTENTION
organic solvents.
z Do not rub too hard, as the carrier
sheet may become scratched or
deformed.
z After cleaning the interior of the
carrier sheet, wait until it has com-
pletely dried before closing it.
z As a guideline, it is recommended
to replace the carrier sheet every
500 scans.
19
Appendix C
Replacing Parts
The glass scanner windows
AUTION
inside the ADF can become hot
when the scanner is used.
Before cleaning inside the
scanner or replacing any parts,
turn off the power, unplug the AC
adapter from the outlet, and wait
for at least 15 minutes.
■ Part No. and Replacement Cycle
for Consumable Parts
The usage count of consumable parts can be checked in
the "Usage Status" screen on the [Device Status] tab.
When parts need to be replaced soon, the "Status" infor-
mation field becomes orange. When parts need to be
replaced immediately, the "Status" information field
becomes red.
The following table specifies the replacement part num-
bers and the standard replacement cycles.
Part Name
Replacement Cycle
PAD ASSY
After every 50,000 sheets
(PA03289-0111)
scanned or once a year
PICK ROLLER
After every 100,000 sheets
(PA03289-0001)
scanned or once a year
To obtain these parts, contact your FUJITSU dealer or
an authorized FUJITSU scanner service provider.
These replacement cycles are rough guidelines when
2
using 64 g/m
(17 lb) A4/Letter woodfree or wood con-
taining paper. They may vary according to the type of
documents scanned, scanner usage, and cleaning fre-
quency.
Use only the PFU LIMITED parts
ATTENTION
specified. Do not use consumable
parts made by other manufacturers.
The following diagram shows the locations of the con-
sumable parts in the scanner. For more details, refer to
the "Operator's Guide".
■ Pad Assy
■ Pick Roller
Pick roller
Pick roller's shaft
20
Imprimir página