AEG ARCTIS Manual de instrucciones - Página 23

2. Set the temperature depending upon the selected operation mode (see

the chapter "Setting the Temperature").

Attention! If you are using the appliance as a freezing unit: Please wait

prior to putting the foodstuff to be frozen, until the freezer interior

temperature has attained -18 °C, or until the red warning display goes

off.

Attention! If you are using this appliance as a cooling unit, after it has

been used as a freezing unit: Please wait until the temperature has

reached 0 °C before putting the foodstuff to be cooled in the appliance.

Temperature Adjustment

1. Press either the „+" (WARMER) or „-" (COLDER) button.

The temperature display switches over and the DESIRED temperature

currently set flashes on the temperature display.

2. To adjust to a warmer temperature, press the „+" (WARMER) button. To

adjust to a colder temperature, press the „-" (COLDER) button. The

changed setting is immediately displayed on the temperature display.

Each time one of the two buttons is pressed again the DESIRED temper-

ature is adjusted by 1 °C.

Note: From a food safety point of view, -18 °C should be considered

cold enough as a storage temperature.

When the buttons are not further pressed after an adjustment has been

made, after a short period (approx. 5 sec.) the temperature display swit-

ches over and again displays the ACTUAL temperature in the freezer

compartment. The display changes from flashing to continuous illumi-

nation.

The following DESIRED temperature settings are possible:

• Operating mode "Freezing": from -15 °C up to -24 °C in 1 °C steps;

• Operation mode "Cooling": from 0 °C up to 16 °C in 1 °C steps;

Attention! If the operation mode "Cooling" is selected, the ambient

temperature at the installation place must be at least 2 °C higher than

the preset DESIRED temperature.

Important! Please regularly check that the storage temperature is

being maintained by checking the red warning light and the tempera-

ture display.