- ページ 23

冷蔵庫 AEG ARCTISのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AEG ARCTIS 40 ページ。 Built-in fridge-freezers
AEG ARCTIS にも： 取扱説明書 (32 ページ), 取扱説明書 (28 ページ), 取扱説明書 (28 ページ), 操作説明 (16 ページ), 取扱説明書 (36 ページ), 取扱説明書 (36 ページ), 取扱説明書 (26 ページ), 取扱説明書および設置マニュアル (28 ページ), 取扱説明書 (36 ページ), 取扱説明書 (27 ページ), 取扱説明書 (34 ページ), ユーザーマニュアル (24 ページ), 取付説明書 (11 ページ), 取扱説明書 (29 ページ), 取扱説明書 (23 ページ), 取付説明書 (25 ページ), 取付説明書 (24 ページ)

ページを印刷する
AEG ARCTIS 取扱説明書
2. Set the temperature depending upon the selected operation mode (see
the chapter "Setting the Temperature").
Attention! If you are using the appliance as a freezing unit: Please wait
prior to putting the foodstuff to be frozen, until the freezer interior
temperature has attained -18 °C, or until the red warning display goes
off.
Attention! If you are using this appliance as a cooling unit, after it has
been used as a freezing unit: Please wait until the temperature has
reached 0 °C before putting the foodstuff to be cooled in the appliance.

Temperature Adjustment

0
1. Press either the „+" (WARMER) or „-" (COLDER) button.
The temperature display switches over and the DESIRED temperature
currently set flashes on the temperature display.
2. To adjust to a warmer temperature, press the „+" (WARMER) button. To
adjust to a colder temperature, press the „-" (COLDER) button. The
changed setting is immediately displayed on the temperature display.
Each time one of the two buttons is pressed again the DESIRED temper-
ature is adjusted by 1 °C.
Note: From a food safety point of view, -18 °C should be considered
cold enough as a storage temperature.
3
When the buttons are not further pressed after an adjustment has been
made, after a short period (approx. 5 sec.) the temperature display swit-
ches over and again displays the ACTUAL temperature in the freezer
compartment. The display changes from flashing to continuous illumi-
nation.
3
The following DESIRED temperature settings are possible:
• Operating mode "Freezing": from -15 °C up to -24 °C in 1 °C steps;
• Operation mode "Cooling": from 0 °C up to 16 °C in 1 °C steps;
Attention! If the operation mode "Cooling" is selected, the ambient
temperature at the installation place must be at least 2 °C higher than
the preset DESIRED temperature.
Important! Please regularly check that the storage temperature is
being maintained by checking the red warning light and the tempera-
ture display.
23