Fujitsu MB91460 SERIES Manual del usuario - Página 39
Navegue en línea o descargue pdf Manual del usuario para Placa base Fujitsu MB91460 SERIES. Fujitsu MB91460 SERIES 45 páginas. 32-bit microcontroller
También para Fujitsu MB91460 SERIES: Primeros pasos (41 páginas), Nota de aplicación (23 páginas), Nota de aplicación (26 páginas), Nota de aplicación (29 páginas), Nota de aplicación (29 páginas)
Imprimir página
SK-91467R-176PMC User Guide
Chapter 6 Programming SWB Monitor Debugger
6 Programming SWB Monitor Debugger
Do program Softune Workbench Monitor Debbuger to external Flash, get the latest Monitor
Debugger Project (91467r_mondeb_uart4_extbus_flash_sram) from our website.
The CPU Mode selection must be set to serial programming mode by setting DIP switch S1
to (Off, On, Off, Off)
Choose MB91F467R as device type and select tab 'External Flash'. Mark the checkboxes
'Enable ext. Flash', 'CS0' and 'Chip erase' (only needed if ext. Flash is not blank).
Figure 6-1: CS settings for SWB Monitor Debugger programming
Please check following entries for register settings:
ASR0: 0100
ACR0: 8820
AWR0: 3378
Select
tab
'Automatic',
browse
to
SWB
monitor
debugger
file
(e.g.
your_path\MONDEB\FLASH\ABS\91467r_mondeb_uart4_extbus_flash_sram.mhx),
press
button "Automatic Mode" and reset microcontroller.
Programmer will execute single steps described in chapter 6.1. After successful
programming, set mode pins to external vector fetch mode (S1: off, off, off, on) and reset
microcontroller. In case of successful startup of the monitor debugger and access to external
SRAM the LED LD1, LD3 and LD7 are lit. Now connection to Softune Workbench can be
started.
© Fujitsu Microelectronics Europe GmbH
- 39 -
FMEMCU-UG-910053-16