Fujitsu MB91460 SERIES Руководство пользователя - Страница 39

Просмотреть онлайн или скачать pdf Руководство пользователя для Материнская плата Fujitsu MB91460 SERIES. Fujitsu MB91460 SERIES 45 страниц. 32-bit microcontroller
Также для Fujitsu MB91460 SERIES: Начало работы (41 страниц), Примечание по применению (23 страниц), Примечание по применению (26 страниц), Примечание по применению (29 страниц), Примечание по применению (29 страниц)

SK-91467R-176PMC User Guide

Chapter 6 Programming SWB Monitor Debugger

6 Programming SWB Monitor Debugger

Do program Softune Workbench Monitor Debbuger to external Flash, get the latest Monitor

Debugger Project (91467r_mondeb_uart4_extbus_flash_sram) from our website.

The CPU Mode selection must be set to serial programming mode by setting DIP switch S1

to (Off, On, Off, Off)

Choose MB91F467R as device type and select tab 'External Flash'. Mark the checkboxes

'Enable ext. Flash', 'CS0' and 'Chip erase' (only needed if ext. Flash is not blank).

Figure 6-1: CS settings for SWB Monitor Debugger programming

Please check following entries for register settings:

ASR0: 0100

ACR0: 8820

AWR0: 3378

Select

tab

'Automatic',

browse

SWB

monitor

debugger

file

(e.g.

your_path\MONDEB\FLASH\ABS\91467r_mondeb_uart4_extbus_flash_sram.mhx),

press

button "Automatic Mode" and reset microcontroller.

Programmer will execute single steps described in chapter 6.1. After successful

programming, set mode pins to external vector fetch mode (S1: off, off, off, on) and reset

microcontroller. In case of successful startup of the monitor debugger and access to external

SRAM the LED LD1, LD3 and LD7 are lit. Now connection to Softune Workbench can be

started.

- 39 -

FMEMCU-UG-910053-16