Fujitsu SK-91460T-144PMC-GPIO Manual del usuario - Página 8
Navegue en línea o descargue pdf Manual del usuario para Placa base Fujitsu SK-91460T-144PMC-GPIO. Fujitsu SK-91460T-144PMC-GPIO 47 páginas. Mb91460 series
Imprimir página
SK-91460T-144PMC-GPIO User Guide
Chapter 1 Overview
1.3.8 I2C Bus
Additional pull-up resistors can be connected to the I²C bus lines by setting the according
Jumpers (JP68, 76, 90, 92) for I²C 0/1.
1.3.9 Emulator System
If the board is used as an emulator target board, the microcontroller must be removed from
the socket and the corresponding probe cable has to be mounted:
Series
V-Chip
Probe cable
Socket
EMA-MB91F467T-NLS-144M08
NQPACK144SD-ND
MB91460
EMA-MB91V460A-002B-80
EMA-MB91F467T-LS-144M08
HQPACK144SD
Table 1-1: Emulation System
Attention:
Socket for Flash chip mounting and probe cable connection is very sensitive. Always fit
probe cable or socket cover very carefully. If any unexpected problems occur, please check
proper connection of MCU/probe cable pads to socket.
Note:
Some customers experience connectivity problems when connecting the MCU into
the socket adapter. Only the small red screwdriver available in your box should be
used to connect the cover (HQPACK) onto the socket (NQPACK).
If the four screws are not tightening equally, then it may cause a poor contact.
Do not screw the cover too tight (max 0.054 Nm). If you have connectivity problems
then please loosen the screws and tighten again the screws equally.
Do not clean NQPACK, YQPACK, and YQSOCKET with steam. Cleaning material will
contaminate inside of connector.
FMEMCU-UG-910074-11
- 8 -
© Fujitsu Microelectronics Europe GmbH