Fujitsu SK-91460T-144PMC-GPIO Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Scheda madre Fujitsu SK-91460T-144PMC-GPIO. Fujitsu SK-91460T-144PMC-GPIO 47. Mb91460 series

SK-91460T-144PMC-GPIO User Guide

Chapter 1 Overview

1.3.8 I2C Bus

Additional pull-up resistors can be connected to the I²C bus lines by setting the according

Jumpers (JP68, 76, 90, 92) for I²C 0/1.

1.3.9 Emulator System

If the board is used as an emulator target board, the microcontroller must be removed from

the socket and the corresponding probe cable has to be mounted:

Series

V-Chip

Probe cable

Socket

EMA-MB91F467T-NLS-144M08

NQPACK144SD-ND

MB91460

EMA-MB91V460A-002B-80

EMA-MB91F467T-LS-144M08

HQPACK144SD

Table 1-1: Emulation System

Attention:

Socket for Flash chip mounting and probe cable connection is very sensitive. Always fit

probe cable or socket cover very carefully. If any unexpected problems occur, please check

proper connection of MCU/probe cable pads to socket.

Note:

Some customers experience connectivity problems when connecting the MCU into

the socket adapter. Only the small red screwdriver available in your box should be

used to connect the cover (HQPACK) onto the socket (NQPACK).

If the four screws are not tightening equally, then it may cause a poor contact.

Do not screw the cover too tight (max 0.054 Nm). If you have connectivity problems

then please loosen the screws and tighten again the screws equally.

Do not clean NQPACK, YQPACK, and YQSOCKET with steam. Cleaning material will

contaminate inside of connector.

FMEMCU-UG-910074-11

- 8 -