Fujitsu SK-91460T-144PMC-GPIO Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Scheda madre Fujitsu SK-91460T-144PMC-GPIO. Fujitsu SK-91460T-144PMC-GPIO 47. Mb91460 series

2 Installation

Carefully remove the board from the shipping carton.

First, check if there are any damages before powering up the evaluation board.

For the power supply a DC input voltage of 9V – 15V is recommended. The positive

voltage (+) must be connected to the center pin, and ground (GND) must be

connected to the shield of the connector X6!

Special care must be taken to the max. input voltage, if the LIN Vs lines are supplied

by the board (JP30, 31, 56, 57), since the input supply voltage is directly applied to pin

1 of X2-X5 without a voltage regulator.

After power-on (Switch S3 or JP66), the yellow power-on LEDs (D20 and D28) should be lit.

If the LEDs do not light up, switch off the power supply and check input polarity and current

capability of the DC supply used.

To use the MCU with the internal flash, which is normally required for the final application,

the CPU mode selection must be set to the Internal Reset Vector mode by setting DIP switch

S1 to (Off, Off, Off, Off)

The in-circuit programming allows the user to program own applications into the Flash

memory. The procedures for Flash programming are described in chapter 6.

If the board shall be used as an emulator target board, switch off the power supply and

remove the microcontroller from the socket. Now the probe cable can be mounted on the

socket. Take care of the pin 1 marking on the socket and fasten the probe cable with the

provided screws.

Do not use any other probe cable than EMA-MB91F467T-NLS-144M08 or

Connect the probe cable to the EMA-MB91V460A-002B-80 Adapter Board. Check all jumper

settings of the evaluation board, the Probe Cable and the Adapter Board.

When turning on the system, be sure to use the following power-up sequence:

1. Power up the Emulator Main Unit (MB2198-01)

2. Power up the Adapter Board (EMA-MB91V460A-002B-80)

3. Power up the target Board (SK-91460T-144PMC-GPIO)

To turn off the system, switch off the components in reverse order, beginning with the target

board.

Please refer to the corresponding user manuals and application notes for the emulator how

to set up the emulator system. After power on, the 'Reset'-LED of the emulator must be off

and the 'Vcc'-LED must be on.

If the Reset LED is still lit, check the settings of the emulator system and the power supply of

the evaluation board.

SK-91460T-144PMC-GPIO User Guide

Chapter 2 Installation

EMA-MB91F467T-LS-144M0

- 9 -

FMEMCU-UG-910074-11