Indesit BCTAA 55 NF Manual de instrucciones de instalación y uso - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de instalación y uso para Frigorífico Indesit BCTAA 55 NF. Indesit BCTAA 55 NF 8 páginas. Refrigerator-freezer
Imprimir páginaRefrigerator-freezer door install guidelines
about swapping left&right
1. Remove the top bar cover fixed by four
screws with caps, then take off two top endcap
coverslips and a top cover buckle
screw ca p（four）
Catch（two）
2. Remove three screws of the top hinge, take
the door hinge as axis, turn over the top hinge
in clockwise direction, then the top hinge
could be removed. Take off the top door, and
put it aside.
Screw（three）
3. Remove middle hinge, screws, screw caps
and plastic inserting nails. Install them on the
other side. Take off the lower door and put it
away.
REFRIGERATOR-FREEZER
4. The disassembly and installation of bottom
parts
A. Disassemble lower hinge and screws.
Then install them on the other side and
consolidate the lower hinge.
Note：the refrigerator-freezer incline angle
less 45°.
The screws
fixed the
bottom-hinge
B、Swap over the position of the adjustable
foot to the other side of the cabinet.
C. Swap over the position of the lower door
block to the other side,
And install the screws and consolidate them.
5. Install the lower door
6.Tighten the screws of the middle hinge on
the reversible side.
7.Remove the existing top door block.Install a
new top door block (not the same one) on the
reversible side.Screw it down,Install the top door.
8. Reuse the disassembled top hinge, three
screws and hinge shaft sleeve.
A. Disassemble the axis of the hinge, swap
over its position to the other side, then
consolidates the axis and screws it down
B. Install the assembled top hinge. Screw it
down and fix it on target side
7
REFRIGERATOR-FREEZER
9. Install the top bar cover and a top cover
buckle. Screw down the four screws and
cover them with caps. Finally insert the top
endcap coverslip
screw ca p（four）
Catch（two）
Attachment：
1. Components that could be transferred
from one side to the other directly after
disassembling are listed below:
top door top endcap coverslip (2pcs)
top cover buckle (1pc)
hinge shaft sleeve (1 or 2pcs)
screws of top hinge (3 pcs)
middle hinge assembly (1 pc)
screws of middle hinge (2 pcs)
insert nail (2 pcs)
screw cap (2 pcs)
door stopper (1 pc)
bottom hinge assembly (1 pc)
screws of lower hinge (3pcs)
2. The component that could be swapped
over from one side to the other only after
reconstruction is listed below：
top hinge assembly
3. Components that could be swapped over
from one side to the other in pairs are listed
below:
adjustable foot with
internal thread
(used
with the lower hinge)
adjustable foot with bolt (fixed at the bottom)
8