Indesit BCTAA 55 NF Kurulum ve Kullanım Kılavuzu için Talimatlar - Sayfa 6

Buzdolabı Indesit BCTAA 55 NF için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu için Talimatlar indirin. Indesit BCTAA 55 NF 8 sayfaları. Refrigerator-freezer

Sayfayı Yazdır

Refrigerator-freezer door install guidelines

about swapping left&right

1. Remove the top bar cover fixed by four

screws with caps, then take off two top endcap

coverslips and a top cover buckle

screw ca p（four）

Catch（two）

2. Remove three screws of the top hinge, take

the door hinge as axis, turn over the top hinge

in clockwise direction, then the top hinge

could be removed. Take off the top door, and

put it aside.

Screw（three）

3. Remove middle hinge, screws, screw caps

and plastic inserting nails. Install them on the

other side. Take off the lower door and put it

away.

REFRIGERATOR-FREEZER

4. The disassembly and installation of bottom

parts

A. Disassemble lower hinge and screws.

Then install them on the other side and

consolidate the lower hinge.

Note：the refrigerator-freezer incline angle

less 45°.

The screws

fixed the

bottom-hinge

B、Swap over the position of the adjustable

foot to the other side of the cabinet.

C. Swap over the position of the lower door

block to the other side,

And install the screws and consolidate them.

5. Install the lower door

6.Tighten the screws of the middle hinge on

the reversible side.

7.Remove the existing top door block.Install a

new top door block (not the same one) on the

reversible side.Screw it down,Install the top door.

8. Reuse the disassembled top hinge, three

screws and hinge shaft sleeve.

A. Disassemble the axis of the hinge, swap

over its position to the other side, then

consolidates the axis and screws it down

B. Install the assembled top hinge. Screw it

down and fix it on target side

REFRIGERATOR-FREEZER

9. Install the top bar cover and a top cover

buckle. Screw down the four screws and

cover them with caps. Finally insert the top

endcap coverslip

screw ca p（four）

Catch（two）

Attachment：

1. Components that could be transferred

from one side to the other directly after

disassembling are listed below:

top door top endcap coverslip (2pcs)

top cover buckle (1pc)

hinge shaft sleeve (1 or 2pcs)

screws of top hinge (3 pcs)

middle hinge assembly (1 pc)

screws of middle hinge (2 pcs)

insert nail (2 pcs)

screw cap (2 pcs)

door stopper (1 pc)

bottom hinge assembly (1 pc)

screws of lower hinge (3pcs)

2. The component that could be swapped

over from one side to the other only after

reconstruction is listed below：

top hinge assembly

3. Components that could be swapped over

from one side to the other in pairs are listed

below:

adjustable foot with

internal thread

(used

with the lower hinge)

adjustable foot with bolt (fixed at the bottom)