AEG Lavatherm 76280AC Manual del usuario - Página 17

Navegue en línea o descargue pdf Manual del usuario para Secadora AEG Lavatherm 76280AC. AEG Lavatherm 76280AC 36 páginas.
También para AEG Lavatherm 76280AC: Manual del usuario (24 páginas), Manual del usuario (28 páginas), Manual del usuario (28 páginas)

AEG Lavatherm 76280AC Manual del usuario

HINTS AND TIPS

ECOLOGICAL HINTS
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled wa-
ter, e.g. for steam ironing. If necessa-
ry clean the condensate before (e.g.
with a coffee filter) to remove possi-
ble small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure there is good air flow in
and around the appliance position.
• Clean the filter after each drying cy-
cle.
• Ensure clothes are spun well in the
washing machine before putting
them in the dryer.
AVERAGE LAUNDRY WEIGHTS
bathrobe
quilt cover
man's work shirt
man's pyjamas
sheet
tablecloth
man's shirt
night dress
pillow case
towelling towel
blouse
ladies' briefs
men's underpants
napkin
tea towel
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust
the sensor to dry with the better results.
To change the sensor conductivity:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time the Dry Plus
and the Anticrease buttons. Hold
down until one of the symbols go
into view on the display:
μS/cm
300-600 μS/cm
μS/cm
3.
Push the Start Pause button again
1200 g
and again until you set necessary
level.
700 g
4.
To memorise this setting push the
600 g
same two buttons as specified in
500 g
point 2.
500 g
WATER CONTAINER FULL —
250 g
INDICATION
200 g
By default the indication LED is always
200 g
on. It comes into the view at the end of
200 g
the cycle or when the water container is
full. When you use an external equip-
200 g
ment to drain the container, the LED
100 g
can be off.
To activate or deactivate the indication:
100 g
1.
Turn the programme dial to availa-
100 g
ble programme.
100 g
2.
Push at the same time the Dry Plus
and Buzzer buttons and hold down
100 g
until you see the correct setting:
– the LED is off and the symbol
LED is permantly off
ENGLISH
low conductivity <300
moderate conductivity
high conductivity >600
goes into the view - The
17