AEG Lavatherm 76280AC Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG Lavatherm 76280AC. AEG Lavatherm 76280AC 36 halaman.
Juga untuk AEG Lavatherm 76280AC: Panduan Pengguna (24 halaman), Panduan Pengguna (28 halaman), Panduan Pengguna (28 halaman)

Halaman Cetak

HINTS AND TIPS

ECOLOGICAL HINTS

• Do not use fabric softener to wash

and then dry. In the tumble dryer

laundry becomes soft automatically.

• Use the condensate as distilled wa-

ter, e.g. for steam ironing. If necessa-

ry clean the condensate before (e.g.

with a coffee filter) to remove possi-

ble small pieces of fluff.

• Always keep the airflow slots on the

bottom of the appliance clear.

• Use the load volumes specified in the

programmes chapter.

• Make sure there is good air flow in

and around the appliance position.

• Clean the filter after each drying cy-

cle.

• Ensure clothes are spun well in the

washing machine before putting

them in the dryer.

AVERAGE LAUNDRY WEIGHTS

bathrobe

quilt cover

man's work shirt

man's pyjamas

sheet

tablecloth

man's shirt

night dress

pillow case

towelling towel

blouse

ladies' briefs

men's underpants

napkin

tea towel

WATER HARDNESS AND

CONDUCTIVITY

Water hardness can be different for dif-

ferent locations. Water hardness has an

effect on the water conductivity and the

operation of the conductivity sensor in

the appliance. If you know the value of

the water conductivity you can adjust

the sensor to dry with the better results.

To change the sensor conductivity:

Turn the programme dial to availa-

ble programme.

Push at the same time the Dry Plus

and the Anticrease buttons. Hold

down until one of the symbols go

into view on the display:

–

μS/cm

–

300-600 μS/cm

–

μS/cm

Push the Start Pause button again

1200 g

and again until you set necessary

level.

700 g

To memorise this setting push the

600 g

same two buttons as specified in

500 g

point 2.

500 g

WATER CONTAINER FULL —

250 g

INDICATION

200 g

By default the indication LED is always

200 g

on. It comes into the view at the end of

200 g

the cycle or when the water container is

full. When you use an external equip-

200 g

ment to drain the container, the LED

100 g

can be off.

To activate or deactivate the indication:

100 g

Turn the programme dial to availa-

100 g

ble programme.

100 g

Push at the same time the Dry Plus

and Buzzer buttons and hold down

100 g

until you see the correct setting:

– the LED is off and the symbol

LED is permantly off

ENGLISH

low conductivity <300

moderate conductivity

high conductivity >600

goes into the view - The