Kohler WELLWORTH WATERGUARD K-3521-CE Manual de instrucciones de instalación
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Aseos Kohler WELLWORTH WATERGUARD K-3521-CE. Kohler WELLWORTH WATERGUARD K-3521-CE 21 páginas. Vitreous china siphon jet toilet
Imprimir página
1. BEFORE YOU BEGIN
HOW TO USE THESE INSTRUCTIONS
Please read these instructions carefully to familiarize yourself with
the required tools, materials, and installation sequences. Follow the
sections that pertain to your particular installation. This will help you
avoid costly mistakes. In addition to proper installation, read all
operating and safety instructions.
INSTALLER HAZARD NOTIFICATION
WARNING: Risk of injury or product damage. Handle
vitreous china products very carefully. Vitreous china can
break and chip if you over-tighten bolts and nuts.
NOTE: Follow all local plumbing codes.
PRODUCT REQUIREMENTS
S
Since all toilets do not have the same supply rough-in, you
may have to change the location of the supply stop to install
this toilet.
S
Closet flange must be 12" (30.5cm) on-center from wall.
S
Seat post holes are on 5-1/2" (14cm) centers.
S
This toilet is designed to flush using 3.5 gallons (13.2 liters)
when the tank refill time is adjusted to between 50 and 55
seconds. Tank refill time is measured from the moment the
flapper ball reseats to the time water stops flowing through
the refill tube. Slightly longer refill time may be necessary to
compensate for permanent or temporary low water
pressure. To adjust the refill time, see "To Adjust Refill
Time", on Page 5.
MATERIALS REQUIRED
S
Closet flange
S
Toilet gasket (wax seal)
S
Toilet T-bolts (2) 5/16" diameter
S
Toilet setting compound (optional)
S
Toilet supply shut-off valve, 3/8" required
A
1007281-2-
WELLWORTH WATERGUARD
R
Español, Página 7
Français, Page 13
VITREOUS CHINA
SIPHON JET TOILET
All information in these instructions is based on the latest product
information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or
availability at any time without notice.
These instructions contain important care, cleaning, and warranty
information – please leave for the consumer.
PRODUCT PROPERTIES
S
Distance from the rim to the water surface is 4-7/8"
(12.4cm).
S
2-1/4" (5.7cm) passageway.
S
For roughing-in and overall dimensions, see Fig. #1.
S
Fixture dimensions are nominal and conform to tolerances
by ANSI standards (A112.19.2).
ORDERING INFORMATION
Wellworth Waterguardr Toilet (elongated)
Wellworth Waterguardr Toilet (round)
When specified:
3/8" supply
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Floor bolts (pr.)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTE: For service parts ordering information, see separate
Service Parts document enclosed with product.
TOOLS REQUIRED
S
10" adjustable wrench
S
12" pipe wrench
S
Screwdriver
S
Tape Measure
S
Tubing cutter
S
Level
S
Putty knife
S
Hacksaw/metal file (for shortening T-bolts)
NOTE: Site preparation may require additional tools.
R
. . . . . . . . .
K-3520-CE
. . . . . . . . . . .
K-3521-CE
K-7638
21401
E2001 Kohler Co.