A-T Controls TRIAO TMC-4 Manual de instalación y funcionamiento - Página 16
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Sistemas de control A-T Controls TRIAO TMC-4. A-T Controls TRIAO TMC-4 19 páginas.
Imprimir página
Two-Position Control
For when operating as two position on/off actuator.
1) Set Supply Type Switch for AC or DC.
2) Set "Motor Type" in SYSTEM CONFIG for AC or DC to match Supply Type Switch setting.
3) Select On-Off input command.
a) Enter COMMAND CONFIG submenu.
b) Select "On-OFF" in "Command Type" setting.
4) Set positioning method.
a) Enter POSITION CONFIG submenu.
b) Set to "Limit SW" in "Position Type" setting
Communication Bus Control
For when using one of the optional communication bus add-on modules.
1) Set Supply Type Switch for AC or DC.
2) Set "Motor Type" in SYSTEM CONFIG for AC or DC to match Supply Type Switch setting.
3) Select communication input command.
a) Enter COMMAND CONFIG submenu.
b) Select "Comms" in "Command Type" setting.
4) Configure communication setting.
a) Enter COMMS CONFIG submenu.
b) Select communication protocol in "Communication Type" setting.
c) Set address and other communication parameters in appropriate setting as needed.
5) Set positioning method.
a) Enter POSITION CONFIG submenu.
b) If operating as 2-position actuator, set to "Limit SW" in "Position Type" setting.
f) If operating as proportional control actuator, set to "Potent" in "Position Type" setting.
i)
Adjust feedback potentiometer to center at 50% position.
ii) In "Calibrate Close Pos" or "Calibrate Open Pos", press [UP] or [DOWN] to drive actuator to 50% position.
iii) Rotate feedback potentiometer until display reads between 1900-2200, then tighten gears.
iv) In "Calibrate Close Pos", press [UP] or [DOWN] to drive actuator to desired 0% position and confirm.
v) In "Calibrate Open Pos", press [UP] or [DOWN] to drive actuator to desired 100% position and confirm.
www.atcontrols.com
16
TMC-4 Control Card
for Electric Actuators
Installation & Maintenance Manual
03/18/21
IOM08139 REVISION 01