Aqua Creek F-702RLSDD Manual - Página 7
Navegue en línea o descargue pdf Manual para Sistemas de elevación Aqua Creek F-702RLSDD. Aqua Creek F-702RLSDD 16 páginas.
Revolution Deep Draft Spa Assembly Instructions
Revolution Deep Draft Spa Assembly Instructions
CONTROL ARM
LIFTING ARM
3/8" NYLOCK
NUT (2)
STEP 5: ADJUST THE SEAT POSITION
The SEAT ASSEMBLY will arrive attached to the SEAT ARM
adjusted to its highest position. To adjust the SEAT ASSEMBLY
to a lower position remove the hardware as shown below.
Slide the SEAT ASSEMBLY to its desired position (in 4 inch
increments) and reinstall the hardware. The maximum
adjustment is 16 inch (down).
DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS
– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE
SEAT ASSEMBLY TO THE CHAIR ARM!
3/8" X 2"
SHOULDER BOLT
5/16" X 4 1/2"
HEX BOLT
Copyright © 2017 Aqua Creek Products All Rights Reserved
STEP 4
3/8" FLAT
WASHER (2)
SEAT ARM
STEP 4: INSTALL SEAT ARM
Locate the SEAT ARM and the following hardware:
•
(2) 1/2" x 2 3/4" SHOULDER BOLT
•
(2) 3/8" FLAT WASHER
•
(2) 3/8" NYLOCK NUT
1/2" X 2 3/4"
Install the SEAT ARM at the ends of the CONTROL
SHOULDER
ARM and LIFTING ARM as shown in the fi gure to the
BOLT (2)
left. Tighten the NYLOCK NUTS until snug as shown in
PHOTO 4. DO NOT OVERTIGHTEN!
(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM
THE MAIN ASSEMBLY)
SEAT ASSEMBLY
ADJUSTED TO
LOWEST POSITION
STEP 5
STEP 5
5/16" FLAT
WASHER (3)
SEAT ARM
5/16" NYLOCK
NUT (2)
Revised 9/19/17
HOLES AT 4"
INTERVALS
ALLOW FOR
ADJUSTMENT
OVER 16"
RANGE
MAIN ASSEMBLY
7