Aqua Creek F-702RLSDD Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Sistem Pengangkatan Aqua Creek F-702RLSDD. Aqua Creek F-702RLSDD 16 halaman.

Halaman Cetak

Revolution Deep Draft Spa Assembly Instructions

CONTROL ARM

LIFTING ARM

3/8" NYLOCK

NUT (2)

STEP 5: ADJUST THE SEAT POSITION

The SEAT ASSEMBLY will arrive attached to the SEAT ARM

adjusted to its highest position. To adjust the SEAT ASSEMBLY

to a lower position remove the hardware as shown below.

Slide the SEAT ASSEMBLY to its desired position (in 4 inch

increments) and reinstall the hardware. The maximum

adjustment is 16 inch (down).

DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS

– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE

SEAT ASSEMBLY TO THE CHAIR ARM!

3/8" X 2"

SHOULDER BOLT

5/16" X 4 1/2"

HEX BOLT

STEP 4

3/8" FLAT

WASHER (2)

SEAT ARM

STEP 4: INSTALL SEAT ARM

Locate the SEAT ARM and the following hardware:

•

(2) 1/2" x 2 3/4" SHOULDER BOLT

•

(2) 3/8" FLAT WASHER

•

(2) 3/8" NYLOCK NUT

1/2" X 2 3/4"

Install the SEAT ARM at the ends of the CONTROL

SHOULDER

ARM and LIFTING ARM as shown in the fi gure to the

BOLT (2)

left. Tighten the NYLOCK NUTS until snug as shown in

PHOTO 4. DO NOT OVERTIGHTEN!

(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM

THE MAIN ASSEMBLY)

SEAT ASSEMBLY

ADJUSTED TO

LOWEST POSITION

STEP 5

5/16" FLAT

WASHER (3)

SEAT ARM

5/16" NYLOCK

NUT (2)

Revised 9/19/17

HOLES AT 4"

INTERVALS

ALLOW FOR

ADJUSTMENT

OVER 16"

RANGE