Aqua Creek Products EZ Series Manual - Página 5

Navegue en línea o descargue pdf Manual para Sistemas de elevación Aqua Creek Products EZ Series. Aqua Creek Products EZ Series 11 páginas. Pool lift and hard seat option
También para Aqua Creek Products EZ Series: Manual de inicio rápido (2 páginas)

Imprimir página

Anchor Installation: New Construction

TOOLS REQUIRED:

TAPE MEASURE

CARPENTERS LEVEL

MARKING PEN

Determine the best location for the lift. Mount the lift at a location that provides 42 inches [107cm] to

48 inches [122cm] deck level to the bottom of the pool (usually the shallow end). Make sure the location

has enough clear deck space to easily transfer. The lift requires at least 6 feet [1.8 meters] of unobstructed

deck to each side of the lift to accomodate easy maneuvering of the lift over the water and back. Keep in

mind this lift will require assistance so locate an area that can accomodate another person.

Locate the concrete anchor socket. Be careful to not lose the protective cap on the anchor as this will

be used to keep dirt and debris out of the socket when the lift is not installed in the anchor.

The setback to the center of the anchor must be no less than 12 inches [30.5cm] and no more than

20 inches [51cm] from the pool wall. The anchor location must also be at least 6 inches [15cm] from any

control joint or edge of concrete slab. Measure the location out using the tape measure and marking

pen. See FIGURE 1 on page 4 for details.

Ground the anchor according to the local code requirements.

Place the anchor in the proper location using the string level and string line to make sure the top of

the anchor will be flush with the finished surface of the new deck. Place a small amount of concrete at

the location of the anchor to hold it in place.

Verify all the measurements for accuracy and pour the deck as you normally would, making sure not

to get any concrete inside the anchor system. Allow the concrete to cure before installing and using the

lift.

NOTE: The concrete deck around the anchor should be a

minimum of 8 inches thick and reinforced with #4 bars at

STRING LINE

STRING LEVEL

10 inches on center, each way. The total concrete pad area

should be at least 60 inches wide and 60 inches long.

Revised 11/1/19