A.H. Systems SAS-563B Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Antena A.H. Systems SAS-563B. A.H. Systems SAS-563B 13 páginas. Active loop antenna
También para A.H. Systems SAS-563B: Manual de instrucciones (14 páginas)
Imprimir página
A.H. Systems Model SAS-563B Active Loop Antenna
CHARGING THE BATTERY
Position the input voltage selector located next to the wall plug on the back of
charger to the proper voltage (either 110 – 120 Vac, 60 Hz or 220 – 240 Vac,
50 Hz). Be sure to check the available voltage and adjust the voltage selector
as needed before use. The amplifier ON-OFF switch must be in the
OFF/CHARGE position to charge the battery. Every hour of charge will result
in two hours of operation for up to 10 hours of charging. Charging for up to 24
hours will not damage the battery. Using the battery charger to operate the
amplifier directly is not recommended.
REPLACING THE BATTERIES
Remove the four 6-32 flat head screws from the bottom of the base unit.
Disconnect the battery lead from the PC card. Re-connect the lead from the
new battery pack to the PC card. Snug the four 6-32 flat head screws.
© A.H. Systems inc. – Mar 2021
REV E
8