A.H. Systems SAS-563B Operation Manual - Page 8

Browse online or download pdf Operation Manual for Antenna A.H. Systems SAS-563B. A.H. Systems SAS-563B 13 pages. Active loop antenna
Also for A.H. Systems SAS-563B: Operation Manual (14 pages)

Print Page

A.H. Systems Model SAS-563B Active Loop Antenna

CHARGING THE BATTERY

Position the input voltage selector located next to the wall plug on the back of

charger to the proper voltage (either 110 – 120 Vac, 60 Hz or 220 – 240 Vac,

50 Hz). Be sure to check the available voltage and adjust the voltage selector

as needed before use. The amplifier ON-OFF switch must be in the

OFF/CHARGE position to charge the battery. Every hour of charge will result

in two hours of operation for up to 10 hours of charging. Charging for up to 24

hours will not damage the battery. Using the battery charger to operate the

amplifier directly is not recommended.

REPLACING THE BATTERIES

Remove the four 6-32 flat head screws from the bottom of the base unit.

Disconnect the battery lead from the PC card. Re-connect the lead from the

new battery pack to the PC card. Snug the four 6-32 flat head screws.

REV E