Aqua Creek Products F-411RPL-AT1-02 Manual - Página 5

Navegue en línea o descargue pdf Manual para Sistemas de elevación Aqua Creek Products F-411RPL-AT1-02. Aqua Creek Products F-411RPL-AT1-02 16 páginas. Ranger-at pool lift

Imprimir página

Anchor Installation: Core-Drill Retro-Fit

Thread the mounting hardware through the smaller anchor jig plate holes and into the

anchor inserts. Make sure to use anti-seize on the threads! Make sure the tops of the inserts are

flush with the bottom of the plate.

NOTE: We recommend using masking tape around the holes on the bottom of the anchor jig plate to help prevent the

anchor plate from being accidentally epoxied to the pool deck.

Place the anchor assembly back into the holes. Wiggle the assembly as you reinsert it to

make sure the epoxy fully coats the threads.

Make sure your anchor assembly is level.

Once the epoxy has set up, remove the hardware and the anchor jig plate. Your lift is now

10.

ready to be mounted to the anchoring system. The anchor jig plate may be recycled or used to

install other anchors.

Bond at least one of the anchor inserts

according to your local code requirements.

For more information see NEC Article

680.26.

Test fit the anchor inserts to make sure

they line up properly. Place the anchor

assembly into the pre-drilled holes and use

a torpedo level to ensure your anchoring

system is level.

Remove the anchor assembly and

fill each hole halfway full with 2-part

construction epoxy.

(CONTINUED)

Revised 6/1/18