Fencee MX10 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Monitor Fencee MX10. Fencee MX10 16 páginas. Remote monitoring of fence parameters
También para Fencee MX10: Manual del usuario (16 páginas)

Imprimir página

7. PAIRING THE MONITOR WITH THE GATEWAY GW10

First, the MX10 Monitor must be paired with the Gateway in order to display the measured

data. Pairing is performed by the following steps:

Place the Monitor and Gateway next to each other, up to a maximum distance

of approx. 30 cm.

The Monitor must be turned off.

Attach the magnet to the Monitor target for> 3 s.

The green and red LEDs on the Monitor will start flashing simultaneously.

Now it is necessary to trigger the pairing mode on the Gateway too.

– description is provided in the Manual for GATEWAY GW10

Upon successful pairing, the Monitor beeps and flashes green.

At the same time it also automatically shuts off so as not to trigger the alarm

immediately, because it is not connected to the fence yet and has no voltage.

It is displayed on the Gateway with a value of 0 kV.

The Monitor is now paired and can be installed on the fence system in the required

measuring point.

The Monitor can only be paired to one Gateway - after pairing with

another Gateway , the previous device will be deleted. The pairing

mode ends automatically after 1 minute or it can be interrupted by

applying a magnet to the target.