Aqua One AquaNano 30 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Producto para el cuidado de mascotas Aqua One AquaNano 30. Aqua One AquaNano 30 7 páginas.
También para Aqua One AquaNano 30: Manual (13 páginas)

Imprimir página

Set Up Instructions

Refer to previous page for location of filter

components.

1. Consider where you are going to place the

aquarium. Keep it away from direct light or

areas with large temperature fluctuations.

2. Place the aquarium on a flat level surface

strong enough to support its weight. We

recommend a genuine aquarium cabinet (sold

separately) rather than general household

furniture.

3. The filter unit comes preassembled with the

exception of the heater and pump.

4. Install the heater in the location show on

previous page. Follow the instructions supplied

with the heater to set the temperature. DO NOT

turn the heater on when it is not submerged.

5. Remove the pump from its box and locate

the straight outlet (as shown in the pump

instructions). Place the pump in the filter as

shown in the diagram on previous page. Align

the pump outlet with the outlet hole in the

front of the filter and push the straight outlet

into the pump. Ensure the pump is secured

firmly using the suction cups on the rear of

the pump.

6. Wash the substrate that will be used in the

aquarium. In order to do this, place a portion

of the substrate into a bucket and run water

through it, churning with your hand. Continue

until the water running out of the bucket is

clear. Place the washed substrate into the

aquarium.

7. Add any rocks or ornaments into the

aquarium.

8. Attach the light unit to the rear of the

aquarium. The light unit should be secured to

the right hand side of the rear glass. Ensure

the fastening screws are tightened enough

that the light unit does not move.

9. It is now time to fill the aquarium with water.

In order to fill the aquarium, it is important to

fill the filter unit first. Because the filter is a

sealed unit, filling the aquarium while the filter

is empty will result in the filter box floatingas

the water level rises. Ensure the correct

dosage of water conditioner (sold separately)

is used whenever adding new water to the

aquarium.

10. Ensure all power cables are dry and plug

the light, heater and pump cables in at the

power outlet. Switch the power on.

11. Test pH and adjust if necessary.