Aqua One AquaNano 30 Podręcznik użytkownika - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Produkt do pielęgnacji zwierząt domowych Aqua One AquaNano 30. Aqua One AquaNano 30 7 stron.
Również dla Aqua One AquaNano 30: Podręcznik (13 strony)
Drukuj stronę
GB
Set Up Instructions
Refer to previous page for location of filter
components.
1. Consider where you are going to place the
aquarium. Keep it away from direct light or
areas with large temperature fluctuations.
2. Place the aquarium on a flat level surface
strong enough to support its weight. We
recommend a genuine aquarium cabinet (sold
separately) rather than general household
furniture.
3. The filter unit comes preassembled with the
exception of the heater and pump.
4. Install the heater in the location show on
previous page. Follow the instructions supplied
with the heater to set the temperature. DO NOT
turn the heater on when it is not submerged.
5. Remove the pump from its box and locate
the straight outlet (as shown in the pump
instructions). Place the pump in the filter as
shown in the diagram on previous page. Align
the pump outlet with the outlet hole in the
front of the filter and push the straight outlet
into the pump. Ensure the pump is secured
firmly using the suction cups on the rear of
the pump.
6. Wash the substrate that will be used in the
aquarium. In order to do this, place a portion
of the substrate into a bucket and run water
through it, churning with your hand. Continue
until the water running out of the bucket is
clear. Place the washed substrate into the
aquarium.
7. Add any rocks or ornaments into the
aquarium.
8. Attach the light unit to the rear of the
aquarium. The light unit should be secured to
the right hand side of the rear glass. Ensure
the fastening screws are tightened enough
that the light unit does not move.
9. It is now time to fill the aquarium with water.
In order to fill the aquarium, it is important to
fill the filter unit first. Because the filter is a
sealed unit, filling the aquarium while the filter
is empty will result in the filter box floatingas
the water level rises. Ensure the correct
dosage of water conditioner (sold separately)
is used whenever adding new water to the
aquarium.
10. Ensure all power cables are dry and plug
the light, heater and pump cables in at the
power outlet. Switch the power on.
11. Test pH and adjust if necessary.
6