Avonic AV-CON300 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Controlador Avonic AV-CON300. Avonic AV-CON300 16 páginas. Ptz camera controller
También para Avonic AV-CON300: Manual del usuario (13 páginas), Manual de inicio rápido (2 páginas)

Imprimir página

Connect the camera

The controller can be connected to the cameras by the 5 channels using RS232 or RS485. The

cameras assigned to channel 1 can also be connected using the 5-pin Phoenix connector.

Maximum distance

If the camera is closer to the keyboard (less than 20 meters), use the RS232 connection. If the

distance is greater than 20 meters (max 1200m, depending on cable and environmental quality) ,

then use RS485 connection. The RS485 setup needs to be ended with a proper terminator impedance

to extinguish line reflections.

RJ45 channels (CH1-CH5)

The Avonic AV-CON300 comes with a single RS232 connecting cable with RJ45 plug to round head pin

8 plug). With this cable only 1 channel can be connected to the controller. This channel can control

up to 7 (VISCA) or up to 10 (PELCO) cameras.

To control the cameras assigned to the other channels, more RJ45 cables are required. The DIN 8

connector is used for RS232. The RS485 requires only 2 wires and can often be attached to a 2-pin

Phoenix connector at the camera. The RJ45 pin-layout diagram is as follows:

Picture

(T-568-A or -B can be used, here is given the picture of T-568-A

as an example)

www.avonic.eu

Function

1.RS485 A+

2.RS485 B-

3.RS232-TX

4.GND

5.GND

6.RS232-RX

7.GND

8.GND