Avonic AV-CON300 Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avonic AV-CON300. Avonic AV-CON300 16 pages. Ptz camera controller
Également pour Avonic AV-CON300 : Manuel de l'utilisateur (13 pages), Manuel de démarrage rapide (2 pages)
Connect the camera
The controller can be connected to the cameras by the 5 channels using RS232 or RS485. The
cameras assigned to channel 1 can also be connected using the 5-pin Phoenix connector.
Maximum distance
If the camera is closer to the keyboard (less than 20 meters), use the RS232 connection. If the
distance is greater than 20 meters (max 1200m, depending on cable and environmental quality) ,
then use RS485 connection. The RS485 setup needs to be ended with a proper terminator impedance
to extinguish line reflections.
RJ45 channels (CH1-CH5)
The Avonic AV-CON300 comes with a single RS232 connecting cable with RJ45 plug to round head pin
8 plug). With this cable only 1 channel can be connected to the controller. This channel can control
up to 7 (VISCA) or up to 10 (PELCO) cameras.
To control the cameras assigned to the other channels, more RJ45 cables are required. The DIN 8
connector is used for RS232. The RS485 requires only 2 wires and can often be attached to a 2-pin
Phoenix connector at the camera. The RJ45 pin-layout diagram is as follows:
Picture
(T-568-A or -B can be used, here is given the picture of T-568-A
as an example)
www.avonic.eu
Function
1.RS485 A+
2.RS485 B-
3.RS232-TX
4.GND
5.GND
6.RS232-RX
7.GND
8.GND
8