AVS Ventvisor Manual de instrucciones de instalación - Página 2

Installation Steps

Remove the triangular plastic mirror cap from the

inside of the door. Loosen (but do not remove) the

mirror mounting screws with a phillips screwdriver.

mirror cap

Position the visor on the black vinyl trim that the window guide clip is attached to. The front end flange will insert underneath the

Inside view of door frame

and mirror cap assembly

With the visor in its final position, remove the remaining tape liner by pulling on free ends.

Visor caps over the window

guide clip

To ensure good adhesion of tape apply pressure along the edge

of the visor flanges.

NOTE: Actual application may vary slightly from illustrations.

screw driver

mirror cap

Remove tape liner from rear flange. Peel back 2" (5 cm) of tape

liner from each end of lateral flange.

rear flange

OUTSIDE mirror cap.

window guide

visor

cross section of visor in place

Retighten mirror mounting screws and replace trian-

mirror cap

Page 2 of 3

free end

lateral flange

front flange

free end

outside black

tape

vinyl trim

inside rubber

window channel

glass

gular plastic mirror cap.

Repeat Steps 1-8 for opposite side.

free end