DG ZCU102 Manual de inicio rápido - Página 11
Navegue en línea o descargue pdf Manual de inicio rápido para Hardware informático DG ZCU102. DG ZCU102 15 páginas. Fpga setup for 2-ch raid0 by nvme-ip demo
Imprimir páginadg_nvmeip_raid0x2_fpgasetup_xilinx_en.doc
6) For KCU105 board by AB17, open Serial console to connect with Enhanced COM port
(Buad rate=115,200 Data=8 bit Non-Parity Stop=1). The console shows System
Controller menu, as shown in Figure 2-8. To set VADJ of FMC to 1.8V, the following step is
recommended.
i. Input '4' to select Adjust FMC Settings.
ii. Input '4' to set FMC VADJ to 1.8V.
iii. Input '0' to return to Main Menu.
iv. Input '2' to get PMBUS Voltages.
v. Input '7' to get VADJ1V8 Voltage. The output voltage of this menu must be equal to
1.8V to confirm that VADJ has been set completely.
For more details of System Controller, please check "UG917 KCU105 Board User Guide"
in section "Appendix C: System Controller".
https://www.xilinx.com/support/documentation/boards_and_kits/kcu105/ug917-kcu105-e
val-bd.pdf
3-Aug-22
Figure 2-8 Setting VADJ on FMC for KCU105
Page 11