DG ZCU102 빠른 시작 매뉴얼 - 페이지 11
{카테고리_이름} DG ZCU102에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DG ZCU102 15 페이지. Fpga setup for 2-ch raid0 by nvme-ip demo
페이지 인쇄dg_nvmeip_raid0x2_fpgasetup_xilinx_en.doc
6) For KCU105 board by AB17, open Serial console to connect with Enhanced COM port
(Buad rate=115,200 Data=8 bit Non-Parity Stop=1). The console shows System
Controller menu, as shown in Figure 2-8. To set VADJ of FMC to 1.8V, the following step is
recommended.
i. Input '4' to select Adjust FMC Settings.
ii. Input '4' to set FMC VADJ to 1.8V.
iii. Input '0' to return to Main Menu.
iv. Input '2' to get PMBUS Voltages.
v. Input '7' to get VADJ1V8 Voltage. The output voltage of this menu must be equal to
1.8V to confirm that VADJ has been set completely.
For more details of System Controller, please check "UG917 KCU105 Board User Guide"
in section "Appendix C: System Controller".
https://www.xilinx.com/support/documentation/boards_and_kits/kcu105/ug917-kcu105-e
val-bd.pdf
3-Aug-22
Figure 2-8 Setting VADJ on FMC for KCU105
Page 11