Dell DX6012S Manual del usuario - Página 37

Navegue en línea o descargue pdf Manual del usuario para Servidor Dell DX6012S. Dell DX6012S 46 páginas. Rack installation instructions — static rails
También para Dell DX6012S: Manual complementario (4 páginas), Instrucciones de instalación del hardware (2 páginas), Manual de instalación y configuración (43 páginas), Manual de instalación y configuración (35 páginas), Manual de introducción (28 páginas), Aviso (28 páginas), Aviso (20 páginas), Visión general (19 páginas), Manual de configuración (9 páginas), Manual de configuración (9 páginas), Nota de publicación (8 páginas), Manual de configuración (7 páginas), Nota de publicación (6 páginas), Nota de publicación (5 páginas), Notas de publicación (5 páginas), Manual de introducción (47 páginas), Instalación (2 páginas), Instalación de bastidores (2 páginas)

7 To keep the mount path persistent across reboot, add the mount path to

/etc/fstab. For example, run the following command:

vi /etc/fstab

Table 5-2 lists the options that must be selected to create a mount path.

Table 5-2. Options to Create a Mount Path

# device name Mount

Path

/dev/sdb1

/u01

Reinstalling the DX Cluster Services Node

Software

The DX Cluster Services Node software requires access to both the external

network and to a dedicated internal network. The internal private network

ensures that the DX Storage Cluster traffic is protected from unauthorized

access and that the external network is isolated from both the PXE boot

server and cluster multicast traffic. The DX Cluster Services Node software

automatically allocates the first half of the Ethernet ports detected on each

NIC interface card to the external network and the second half of the

Ethernet ports detected on each NIC interface card to the internal network.

All NICs allocated to a network are bonded into a bond interface using

mode 6 or balance alb bonding. For example, on a server with four LOM ports

and a quad port NIC adapter, LOM ports 0-1 and NIC adapter ports 0-1 are

allocated to the external network in a balance-alb bond interface and LOM

ports 2-3 and NIC adapter ports 2-3 are allocated to the internal network in a

balance-alb bond interface.

NOTE:

Network switch configuration is outside the scope of the DX Cluster

Services Node software. Switches must be properly configured by a system

administrator to ensure correct connectivity and bonding mode support.

Administrators must not connect the configured internal network ports to the

external network.

fs type

options

ext3

defaults

dump-freq pass-num

Disaster Recovery