Dell PowerEdge 2300 Manual de actualización - Página 16

Navegue en línea o descargue pdf Manual de actualización para Servidor Dell PowerEdge 2300. Dell PowerEdge 2300 24 páginas. Vga card installation instructions
También para Dell PowerEdge 2300: Manual de instalación (2 páginas), Inicio rápido y conexiones (5 páginas), Manual de actualización (23 páginas), Instrucciones de instalación de la estantería (26 páginas), Instrucciones de instalación (1 páginas)

1-12

Dell PowerEdge Systems — Microprocessor Upgrade

Remove the microprocessors.

See "Removing the Microprocessors", found later in this document.

Remove and replace the guide brackets.

See "Removing and Replacing the Guide Brackets", found later in this

document.

Install the upgrade microprocessor.

See "Installing the Upgrade Microprocessor", found later in this document.

Reassemble and check the system.

See "Reassembling and Checking the System", found later in this document.

!" #

To remove the current microprocessors from the system board, perform the follow-

ing steps.

Unscrew and remove the two large thumbscrew retention pins that secure the

microprocessor to the system board.

Press the microprocessor's release latches inward until they snap into position

(see Figure 1-4).

NOTE: Figure 1-4 illustrates the SEC cartridge. The heat sink on the single-edge

connector cartridge 2 (SECC2) package is different.

Grasp the microprocessor assembly firmly and pull it away from the microproces-

sor guide bracket assembly.

You must use up to 15 pounds (lb) of force to disengage the microprocessor

from the connector.