Dell PowerEdge 2300 업그레이드 매뉴얼 - 페이지 16
{카테고리_이름} Dell PowerEdge 2300에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2300 24 페이지. Vga card installation instructions
Dell PowerEdge 2300에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 빠른 시작 및 연결 (5 페이지), 업그레이드 매뉴얼 (23 페이지), 랙 설치 지침 (26 페이지), 설치 지침 (1 페이지)
1-12
Dell PowerEdge Systems — Microprocessor Upgrade
2.
Remove the microprocessors.
See "Removing the Microprocessors", found later in this document.
3.
Remove and replace the guide brackets.
See "Removing and Replacing the Guide Brackets", found later in this
document.
4.
Install the upgrade microprocessor.
See "Installing the Upgrade Microprocessor", found later in this document.
5.
Reassemble and check the system.
See "Reassembling and Checking the System", found later in this document.
!" #
To remove the current microprocessors from the system board, perform the follow-
ing steps.
1.
Unscrew and remove the two large thumbscrew retention pins that secure the
microprocessor to the system board.
2.
Press the microprocessor's release latches inward until they snap into position
(see Figure 1-4).
NOTE: Figure 1-4 illustrates the SEC cartridge. The heat sink on the single-edge
connector cartridge 2 (SECC2) package is different.
3.
Grasp the microprocessor assembly firmly and pull it away from the microproces-
sor guide bracket assembly.
You must use up to 15 pounds (lb) of force to disengage the microprocessor
from the connector.