Dell PowerEdge 2300 업그레이드 매뉴얼 - 페이지 17
{카테고리_이름} Dell PowerEdge 2300에 대한 업그레이드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2300 24 페이지. Vga card installation instructions
Dell PowerEdge 2300에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지), 빠른 시작 및 연결 (5 페이지), 업그레이드 매뉴얼 (23 페이지), 랙 설치 지침 (26 페이지), 설치 지침 (1 페이지)
페이지 인쇄
support.dell.com
microprocessor
!
!" #
!
$
%
To remove the guide bracket assembly, perform the following steps:
1.
Remove any terminator card installed in the guide bracket.
2.
Remove any microprocessor assembly installed in the guide bracket.
3.
Use a #2 Phillips screwdriver to loosen the four captive nuts that secure the
guide bracket assembly to the system board (see Figure 1-5).
4.
Lift up the assembly to remove it from the four threaded posts.
To install the new guide bracket assembly, perform the following steps:
1.
Position the guide bracket over the four threaded posts (see Figure 1-6).
You can install the guide bracket only one way (the captive nuts will not align
with the threaded posts if installed incorrectly).
2.
Tighten the four captive nuts using a #2 Phillips screwdriver.
Dell PowerEdge Systems — Microprocessor Upgrade
release latches (2)
thumbscrews (2)
heat sink
1-13