Dell PowerEdge 2300 Panduan Peningkatan - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Peningkatan untuk Server Dell PowerEdge 2300. Dell PowerEdge 2300 24 halaman. Vga card installation instructions
Juga untuk Dell PowerEdge 2300: Setup Manual (2 halaman), Mulai Cepat & Koneksi (5 halaman), Panduan Peningkatan (23 halaman), Petunjuk Pemasangan Rak (26 halaman), Petunjuk Instalasi (1 halaman)
Halaman Cetak
support.dell.com
microprocessor
!
!" #
!
$
%
To remove the guide bracket assembly, perform the following steps:
1.
Remove any terminator card installed in the guide bracket.
2.
Remove any microprocessor assembly installed in the guide bracket.
3.
Use a #2 Phillips screwdriver to loosen the four captive nuts that secure the
guide bracket assembly to the system board (see Figure 1-5).
4.
Lift up the assembly to remove it from the four threaded posts.
To install the new guide bracket assembly, perform the following steps:
1.
Position the guide bracket over the four threaded posts (see Figure 1-6).
You can install the guide bracket only one way (the captive nuts will not align
with the threaded posts if installed incorrectly).
2.
Tighten the four captive nuts using a #2 Phillips screwdriver.
Dell PowerEdge Systems — Microprocessor Upgrade
release latches (2)
thumbscrews (2)
heat sink
1-13