Allied Telesis SB251-08 Nota de publicación - Página 9

Navegue en línea o descargue pdf Nota de publicación para Software Allied Telesis SB251-08. Allied Telesis SB251-08 12 páginas. Patch for switchblade 4000 series switches and at-9800 series switches

Imprimir página
Patch SB251-08 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches
Patch SB251-08 for Software Release 2.5.1
C613-10361-00 REV H
PCR: 03023
Module: SWI
The SET SWITCH PORT ACCEPTABLE command did not work correctly
on all specified port numbers. This issue has been resolved.
PCR: 03028
Module: SWI
A warning message was generated when a slave line card was not
initialised, and the configuration script was not loaded. This issue has been
resolved.
PCR: 03030
Module: SWI
RIP was not operating correctly because a MAC address search returned the
wrong port number. This issue has been resolved.
PCR: 03031
Module: FIREWALL
The ADD FIREWALL POLICY RULE command included an erroneous
check on port ranges for non-NAT rules. This check is now restricted to
NAT rules.
PCR: 03034
Module: SWI
Executing the SET IP INTERFACE and SET IPX INTERFACE commands on
a SwitchBlade produced debugging output on the ASYN port. This issue
has been resolved.
PCR: 03037
Module: QOS
A new value is now shown in the output of the SHOW QOS POLICY
command. This is the value of the port bandwidth used when the default
traffic class percentage bandwidth is set on a QoS Policy.
PCR: 03039
Module: SWITCH, IPG
Adding a layer 2 filter on a SwitchBlade did not block traffic to the end host
as intended. This issue has been resolved.
PCR: 03043
Module: SWITCH
On a SwitchBlade, PCI errors occurred periodically after a line card was
hotswapped. This issue has been resolved.
PCR: 03047
Module: CORE
The board revision number for the slave control blade was erroneously set
to the same number as the master control blade. This issue has been
resolved.
PCR: 03428
Module: STP
If a port belongs to an enabled STP instance, but the port has been disabled
from STP operation with the DISABLE STP PORT command, the port will
not respond to ARP requests. This patch implements a workaround that
allows disabled STP ports to respond to ARP requests.
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
9