- ページ 9

ソフトウェア Allied Telesis SB251-08のPDF リリースノートをオンラインで閲覧またはダウンロードできます。Allied Telesis SB251-08 12 ページ。 Patch for switchblade 4000 series switches and at-9800 series switches

ページを印刷する

Patch SB251-08 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches

Patch SB251-08 for Software Release 2.5.1

C613-10361-00 REV H

PCR: 03023

Module: SWI

The SET SWITCH PORT ACCEPTABLE command did not work correctly

on all specified port numbers. This issue has been resolved.

PCR: 03028

Module: SWI

A warning message was generated when a slave line card was not

initialised, and the configuration script was not loaded. This issue has been

resolved.

PCR: 03030

Module: SWI

RIP was not operating correctly because a MAC address search returned the

wrong port number. This issue has been resolved.

PCR: 03031

Module: FIREWALL

The ADD FIREWALL POLICY RULE command included an erroneous

check on port ranges for non-NAT rules. This check is now restricted to

NAT rules.

PCR: 03034

Module: SWI

Executing the SET IP INTERFACE and SET IPX INTERFACE commands on

a SwitchBlade produced debugging output on the ASYN port. This issue

has been resolved.

PCR: 03037

Module: QOS

A new value is now shown in the output of the SHOW QOS POLICY

command. This is the value of the port bandwidth used when the default

traffic class percentage bandwidth is set on a QoS Policy.

PCR: 03039

Module: SWITCH, IPG

Adding a layer 2 filter on a SwitchBlade did not block traffic to the end host

as intended. This issue has been resolved.

PCR: 03043

Module: SWITCH

On a SwitchBlade, PCI errors occurred periodically after a line card was

hotswapped. This issue has been resolved.

PCR: 03047

Module: CORE

The board revision number for the slave control blade was erroneously set

to the same number as the master control blade. This issue has been

resolved.

PCR: 03428

Module: STP

If a port belongs to an enabled STP instance, but the port has been disabled

from STP operation with the DISABLE STP PORT command, the port will

not respond to ARP requests. This patch implements a workaround that

allows disabled STP ports to respond to ARP requests.

Network affecting: No