Dell Networking S4810 Manual de configuración - Página 9

Navegue en línea o descargue pdf Manual de configuración para Interruptor Dell Networking S4810. Dell Networking S4810 17 páginas. Open networking
También para Dell Networking S4810: Especificaciones (2 páginas), Manual de configuración (17 páginas), Manual de instalación (42 páginas), Manual de introducción (16 páginas)

2.9

Configure spanning tree on edge ports

FTOS(conf-if-range-te-0/0-47)#spanning-tree rstp edge-port

FTOS(conf-if-range-te-0/0-47)#exit

FTOS(conf)#protocol spanning-tree rstp

FTOS(conf-rstp)#no disable

FTOS(conf-rstp)#exit

2.10

These commands configure the switch interconnect as a LAG.

FTOS(conf)#interface Port-channel 1

FTOS(conf-if-po-1)#mtu 12000

FTOS(conf-if-po-1)#switchport

FTOS(conf-if-po-1)#no shutdown

FTOS(conf-if-po-1)#exit

2.11

These commands assigns 40Gb QSFP ports to the Port Channel.

FTOS(conf)#interface range fortyGigE 0/48 , fortyGigE 0/52

FTOS(conf-if-range-fo-0/48,fo-0/52)#no ip address

FTOS(conf-if-range-fo-0/48,fo-0/52)#mtu 12000

FTOS(conf-if-range-te-0/48,fo-0/52)#no shutdown

FTOS(conf-if-range-fo-0/48,fo-0/52)#flowcontrol rx on tx off

FTOS(conf-if-range-fo-0/48,fo-0/52)#port-channel-protocol lacp

FTOS(conf-if-range-fo-0/48,fo-0/52-lacp)#port-channel 1 mode active

FTOS(conf-if-range-fo-0/48,fo-0/52-lacp)#exit

FTOS(conf-if-range-fo-0/48,fo-0/52)#exit

FTOS(conf)#exit

2.12

FTOS#copy running-config startup-config

2.13

Repeat the commands from section 2 to configure the second switch.

Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in

a non-default VLAN, refer to the documentation for your switch.

SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs