- ページ 9

スイッチ Dell Networking S4810のPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell Networking S4810 17 ページ。 Open networking
Dell Networking S4810 にも：仕様 (2 ページ), 設定マニュアル (17 ページ), インストレーション・マニュアル (42 ページ), スタートマニュアル (16 ページ)

2.9

Configure spanning tree on edge ports

FTOS(conf-if-range-te-0/0-47)#spanning-tree rstp edge-port

FTOS(conf-if-range-te-0/0-47)#exit

FTOS(conf)#protocol spanning-tree rstp

FTOS(conf-rstp)#no disable

FTOS(conf-rstp)#exit

2.10

These commands configure the switch interconnect as a LAG.

FTOS(conf)#interface Port-channel 1

FTOS(conf-if-po-1)#mtu 12000

FTOS(conf-if-po-1)#switchport

FTOS(conf-if-po-1)#no shutdown

FTOS(conf-if-po-1)#exit

2.11

These commands assigns 40Gb QSFP ports to the Port Channel.

FTOS(conf)#interface range fortyGigE 0/48 , fortyGigE 0/52

FTOS(conf-if-range-fo-0/48,fo-0/52)#no ip address

FTOS(conf-if-range-fo-0/48,fo-0/52)#mtu 12000

FTOS(conf-if-range-te-0/48,fo-0/52)#no shutdown

FTOS(conf-if-range-fo-0/48,fo-0/52)#flowcontrol rx on tx off

FTOS(conf-if-range-fo-0/48,fo-0/52)#port-channel-protocol lacp

FTOS(conf-if-range-fo-0/48,fo-0/52-lacp)#port-channel 1 mode active

FTOS(conf-if-range-fo-0/48,fo-0/52-lacp)#exit

FTOS(conf-if-range-fo-0/48,fo-0/52)#exit

FTOS(conf)#exit

2.12

FTOS#copy running-config startup-config

2.13

Repeat the commands from section 2 to configure the second switch.

Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in

a non-default VLAN, refer to the documentation for your switch.

SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs