3 Day Blinds HONEYCOMB SHADE ARCHES Primeros pasos

Navegue en línea o descargue pdf Primeros pasos para Mobiliario interior 3 Day Blinds HONEYCOMB SHADE ARCHES. 3 Day Blinds HONEYCOMB SHADE ARCHES 6 páginas.

Imprimir página
HONEYCOMB SHADE
ARCHES
GETTING STARTED
A few simple tools are required:
Steel Tape Measure
Power Drill and
Flathead & Phillips
Drill Bits
Included in your order is all the hardware necessary for a
normal installation. Depending on the mounting surface,
fasteners other than the screws provided may be required.
Wall board and plaster require the use of anchors such as
expansion or toggle bolts. Bricks, tile and stone need special
plugs and drill bits. Wood should always be pre-drilled to
avoid splitting.
Professional installation is also available in most areas,
call 800-800-3329.
STANDARD HARDWARE
Screws
Mounting Brackets
OPTIONAL HARDWARE
Side Mount Bracket
1
| Honeycomb Shade Arches
Pencil
Level
(for outside mount)
Awl (or tool for
Screwdriver
starting a screw hole)
Arch Support Clip(s)
with Screw(s)
INSIDE MOUNT
HALF ARCH INSTALLATION
Vertical Rail
Horizontal Rail
NOTE: To avoid damaging your shade, remove the shade
from the vertical brackets and collapse the arch while
installing the arch support clips.
• Your half arch has been
shipped in the closed
position. When fanned, the
rails will form a 90 degree
angle. Note that the vertical
rail is shorter than the
horizontal rail.
• Install brackets
/
" in from
1
4
the front edge and equally
spaced on the vertical and
horizontal sides of the
window opening.
• Before fanning the shade,
install the bottom rail onto
the horizontal mounting clips
by hooking the groove at
the front of the rail into the
mounting bracket hooks and
rotate into place.
• Fan the shade so that
the vertical rail rests upon the
horizontal rail. Attach
the vertical rail to the
vertical brackets.
• Position one arch support
clip at the center portion of
the arch opening so that the
clip holds a cell of the fabric.
Install the arch support clip
with a screw through the
top of the clip. If required,
space additional clips evenly
along the arch. Place the
appropriate cell of fabric into
the arch support bracket(s).