3 Day Blinds HONEYCOMB SHADE ARCHES Aan de slag

Blader online of download pdf Aan de slag voor {categorie_naam} 3 Day Blinds HONEYCOMB SHADE ARCHES. 3 Day Blinds HONEYCOMB SHADE ARCHES 6 pagina's.

Pagina afdrukken

HONEYCOMB SHADE

ARCHES

GETTING STARTED

A few simple tools are required:

Steel Tape Measure

Power Drill and

Flathead & Phillips

Drill Bits

Included in your order is all the hardware necessary for a

normal installation. Depending on the mounting surface,

fasteners other than the screws provided may be required.

Wall board and plaster require the use of anchors such as

expansion or toggle bolts. Bricks, tile and stone need special

plugs and drill bits. Wood should always be pre-drilled to

avoid splitting.

Professional installation is also available in most areas,

call 800-800-3329.

STANDARD HARDWARE

Screws

Mounting Brackets

OPTIONAL HARDWARE

Side Mount Bracket

| Honeycomb Shade Arches

Pencil

Level

(for outside mount)

Awl (or tool for

Screwdriver

starting a screw hole)

Arch Support Clip(s)

with Screw(s)

INSIDE MOUNT

HALF ARCH INSTALLATION

Vertical Rail

Horizontal Rail

NOTE: To avoid damaging your shade, remove the shade

from the vertical brackets and collapse the arch while

installing the arch support clips.

• Your half arch has been

shipped in the closed

position. When fanned, the

rails will form a 90 degree

angle. Note that the vertical

rail is shorter than the

horizontal rail.

• Install brackets

" in from

the front edge and equally

spaced on the vertical and

horizontal sides of the

window opening.

• Before fanning the shade,

install the bottom rail onto

the horizontal mounting clips

by hooking the groove at

the front of the rail into the

mounting bracket hooks and

rotate into place.

• Fan the shade so that

the vertical rail rests upon the

horizontal rail. Attach

the vertical rail to the

vertical brackets.

• Position one arch support

clip at the center portion of

the arch opening so that the

clip holds a cell of the fabric.

Install the arch support clip

with a screw through the

top of the clip. If required,

space additional clips evenly

along the arch. Place the

appropriate cell of fabric into

the arch support bracket(s).