3 Day Blinds HONEYCOMB SHADE ARCHES Aan de slag - Pagina 3

Blader online of download pdf Aan de slag voor {categorie_naam} 3 Day Blinds HONEYCOMB SHADE ARCHES. 3 Day Blinds HONEYCOMB SHADE ARCHES 6 pagina's.

Pagina afdrukken

Bracket assembly and mount

• Pull the cord lock assembly partially out of the

headrail and slide the side mount bracket on as

shown. Push the cord lock as assembly and side

mount bracket back all the way into the rail.

• Remove the end cap from the opposite end of the

headrail. Slide the remaining side mount bracket on

the headrail. Replace the end cap before sliding the

side mount abracket all the way into the headrail.

| Honeycomb Shade Arches

• Line up the top of the side

mount bracket with the

desired height of the top of

the headrail.

• Mark holes for screws. Side

mount brackets must be

level. Remove side mount

brackets and drill holes.

• Insert bugle head screws

for keyhole slots only.

Approximately

" of

the screw should be

left protruding.

Rail

• Remove the end caps on the

arch rail. Slide the arch rail

onto the tabs on the top of

the side mount bracket.

• Slide the rail all of the

way to end of the side

mount bracket.

• Reattach the end caps.

• Hook one side mount bracket onto the screw in the

window frame, using the keyhole slot. Bring the other end

side mount bracket over the screw at the other side of the

frame. Slide down, ﬂ exing bracket inward until the screw

engages in the keyhole slot.

• Make sure both side mount brackets are slipped down all

the way in the keyhole slot so that the screw is in the top

portion of the keyhole slot. Install a screw in the bottom

hole of each side mount bracket. Tighten all screws.

Note: To avoid damaging your shade, allow the shade to

gently fall forward out of the way while installing the arch

support clips.

• Position one arch support

clip at the center portion of

the arch opening so that the

clip holds a cell of the fabric.

Install the arch support clip

with a screw through the

top of the clip. If required,

space additional clips evenly

along the arch. Place the

appropriate cell of fabric into

the arch support bracket(s).