- ページ 3
室内装飾品 3 Day Blinds HONEYCOMB SHADE ARCHESのPDF はじめにをオンラインで閲覧またはダウンロードできます。3 Day Blinds HONEYCOMB SHADE ARCHES 6 ページ。
ページを印刷するBracket assembly and mount
• Pull the cord lock assembly partially out of the
headrail and slide the side mount bracket on as
shown. Push the cord lock as assembly and side
mount bracket back all the way into the rail.
• Remove the end cap from the opposite end of the
headrail. Slide the remaining side mount bracket on
the headrail. Replace the end cap before sliding the
side mount abracket all the way into the headrail.
3
| Honeycomb Shade Arches
• Line up the top of the side
mount bracket with the
desired height of the top of
the headrail.
• Mark holes for screws. Side
mount brackets must be
level. Remove side mount
brackets and drill holes.
• Insert bugle head screws
for keyhole slots only.
Approximately
/
" of
1
8
the screw should be
left protruding.
Rail
• Remove the end caps on the
arch rail. Slide the arch rail
onto the tabs on the top of
the side mount bracket.
• Slide the rail all of the
way to end of the side
mount bracket.
• Reattach the end caps.
• Hook one side mount bracket onto the screw in the
window frame, using the keyhole slot. Bring the other end
side mount bracket over the screw at the other side of the
frame. Slide down, fl exing bracket inward until the screw
engages in the keyhole slot.
• Make sure both side mount brackets are slipped down all
the way in the keyhole slot so that the screw is in the top
portion of the keyhole slot. Install a screw in the bottom
hole of each side mount bracket. Tighten all screws.
Note: To avoid damaging your shade, allow the shade to
gently fall forward out of the way while installing the arch
support clips.
• Position one arch support
clip at the center portion of
the arch opening so that the
clip holds a cell of the fabric.
Install the arch support clip
with a screw through the
top of the clip. If required,
space additional clips evenly
along the arch. Place the
appropriate cell of fabric into
the arch support bracket(s).