- ページ 4
室内装飾品 3 Day Blinds HONEYCOMB SHADE ARCHESのPDF はじめにをオンラインで閲覧またはダウンロードできます。3 Day Blinds HONEYCOMB SHADE ARCHES 6 ページ。
ページを印刷するOUTSIDE MOUNT
HALF ARCH INSTALLATION
Vertical Rail
Horizontal Rail
NOTE: To avoid damaging your shade, remove the shade
from the vertical brackets and collapse the arch while
installing the arch support clips.
4
| Honeycomb Shade Arches
• Your half arch has been
shipped in the closed
position. When fanned, the
rails will form a 90 degree
angle. Note that the vertical
rail is shorter than the
horizontal rail.
• Install brackets in desired
location on outside of the
window sill or wall.
• Before fanning the shade,
install the bottom rail onto
the horizontal mounting clips
by hooking the groove at
the front of the rail into the
mounting bracket hooks and
rotate into place.
• Fan the shade so that
the vertical rail rests upon
the horizontal rail. Attach
the vertical rail to the
vertical brackets.
• Position one arch support
clip at the center portion of
the arch opening so that the
clip holds a cell of the fabric.
Install the arch support clip
with a screw through the
back of the clip. If required,
space additional clips evenly
along the arch. Place the
appropriate cell of fabric into
the arch support bracket(s).
FULL ARCH INSTALLATION
Your arch top shade has been shipped in the closed position
and inserted into it's own bottom rail. Remove the end cap
located opposite the arch stack.
• For MidCell, TwinCell and GrandCell Honeycomb Shades:
Insert the loose end of the adhesive strip into the top
cell of the arch. DO NOT remove the protective covering.
Continue inserting the strip into the arch until there is no
remaining slack.
• For MiniCell Shades:
The top cell has been slit to accommodate the adhesive
strip. Remove the protective covering on the loose end of
the adhesive strip. Fold the strip over so that it adheres to
the top of the slit cell.
• For Micro and 1" Pleated Shades:
Remove the protective covering on the remaining adhesive
strip. Fold the strip over so that it adheres to the top pleat
on the stack.
• One side of the arch has
already been attached to an
adhesive trip which has been
inserted into the bottom rail.
Slide the strip with the arch
attached out of the bottom
rail until the arch is even with
the end of the bottom rail.
• Open the arch to it's fully
fanned position and gently
insert the remaining half of
the arch into the bottom rail.
Only the very last cell which
encases the adhesive strip
should be inserted into the
bottom rail.
• For MidCell, TwinCell and
Grand Cell only: Gently
remove the protective
covering from the last 2" of
the adhesive strip. Gently
press the cellular arch fabric
against the adhesive
to hold your arch securely
in place.
• Replace the end cap on the
bottom rail of your fully
assembled arch.
• Install brackets in desired
location on outside of the
window sill or wall.