Dell Z9100-ON Manual de instalación - Página 24

Navegue en línea o descargue pdf Manual de instalación para Interruptor Dell Z9100-ON. Dell Z9100-ON 43 páginas. Open networking
También para Dell Z9100-ON: Manual de instalación (45 páginas), Manual de instalación (45 páginas)

Imprimir página

Power Supplies

The Z9100–ON ships with two AC or DC power supplies.

The Z9100–ON supports AC or DC power supplies with two air-flow directions (from the I/O to the PSU

and from the PSU to the I/O). Two PSUs are required for full redundancy, but the system can operate with

a single PSU.

The PSUs are field replaceable. When running with full redundancy (two power supplies installed and

running), you can remove and replace one PSU without disrupting traffic.

CAUTION: To prevent electrical shock, ensure that the Z9100-ON is grounded properly. If you do

not ground your equipment correctly, excessive emissions may result. Use a qualified electrician

to ensure that the power cables meet your local electrical requirements.

NOTE: If you use a single PSU, install a blank plate in the other PSU slot. Dell Networking

recommends using power supply 2 (PSU2) as the blank plate slot. Use a #1 Philips screw driver to

install the blank plate.

NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist

or heel ground strap when handling the Z9100–ON and its components.

Components

The following power supply options are available for the Z9100–ON.

•

AC or DC power supply with integrated fan

•

AC or DC power supply with integrated reverse flow fan

Power supply 1 (PSU1) is on the left side of the chassis; power supply 2 (PSU2) is on the right side of the

chassis.

Figure 11. Z9100–ON Power Supply Units (PSUs)

Power Supplies