Award PPS1202 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Campana de ventilación Award PPS1202. Award PPS1202 16 páginas.

Controls

Button Function

Turns the lights on/off at maximum strength.

Turns the motor on/off at speed one.

Keeping the button pressed for approximately 2 seconds starts/stops the temperature

sensor.

Turns the Motor on at speed two.

Press and hold the button for approximately 5 seconds, with all the loads

turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The

relevant LED flashes twice to confirm.

To turn the alarm off, press the button again and hold for at least 5 seconds.

The relevant LED flashes once.

Turns the Motor on at speed three.

Press and hold the button for approximately 3 seconds, with all the loads turned

off (Motor and Lights), to perform a reset. The LED S1 flashes three times.

Turns the Motor on at INTENSIVE Speed.

This speed is timed to run for 6 minutes. At the end of this time, the system

returns automatically to the speed that was set before. If it is activated with the

motor turned off, the hood will switch to OFF at the end of the time.

Press and hold for 5 seconds to enable the remote control, indicated by the

LED flashing twice.

Press and hold for 5 seconds to disable the remote control, indicated by the

LED flashing just once.

Signals the Metal Grease Filter saturation alarm, indicating that it is necessary

to wash the filters. The alarm is triggered after the Hood has been in operation

for 100 working hours.

When this is activated, it signals the Activated Charcoal Filter saturation alarm,

indicating that the filter must be changed; the Metal Grease Filters must also

be washed. The Activated Charcoal Filter saturation alarm comes into operation

after the Hood has been working for 200 hours.

Led

Fixed.

1 flash of LEDs T2

and T3 algorithm

activated.

2 flashes of LEDs

T2 and T3 algorithm

deactivated.

Fixed.

Flashing.