EarthWay 2170 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Esparcidor EarthWay 2170. EarthWay 2170 8 páginas. Commercial broadcast spreader with side spread control
También para EarthWay 2170: Manual de instrucciones de montaje y funcionamiento (6 páginas), Manual de instrucciones de montaje y funcionamiento (8 páginas), Manual de instrucciones de montaje (12 páginas), Manual de instrucciones de montaje y funcionamiento (6 páginas), Manual de instrucciones de montaje (10 páginas)

Imprimir página

Drive wheel side

2" Cotter Pin

Bushing

Install the axle

Coast wheel side

as shown above

1" Cotter Pin

Bushing

7. Slide axle bushing over axle and into axle bearing to both sides as shown.

8. Install drive wheel onto the axle and align with the cotter pin hole nearest to

lower handles as shown. Insert 2" cotter pin through wheel and through axle.

Bend with pliers to prevent pin from falling out.

Upper Handles

9. Install coast wheel onto the axle fully, then using outside cotter pin hole,

insert 1" cotter pin through axle (not thru the wheel). Bend with pliers to

1/4-20

prevent pin from falling out.

1/4-20 x 2"

Locknuts

Hex Head

Bolt

TURN SPREADER UPRIGHT ON TO WHEELS.

Gauge &

Lever Assembly

Shut-Off

Rotate

Plate

Pivot

Handle Shaft

Pivot Rod

with extra bend

Long end

10. Insert 2" bolt through Gauge & Lever assembly, next through upper handle,

then the handle shaft and then the other upper handle and secure with locknut.

TIGHTEN ALL HARDWARE NOW

Insert Pivot Rod

into Shut-Off

and rotate to secure

11. Insert pivot rod into shut-off plate as shown.

Turn to lock in place.

Pivot

Rod

Angle

12. Insert other end of pivot rod into pivot and bracket assembly as shown. Turn

to lock in place.

Attaching

Arm

PAGE 3